300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Master the examcollection 300 115 Implementing Cisco IP Switched Networks content and be ready for exam day success quickly with this Exambible 9tut ccnp switch 300 115 braindumps. We guarantee it!We make it a reality and give you real cisco 300 115 questions in our Cisco cisco 300 115 dumps braindumps.Latest 100% VALID Cisco ccnp 300 115 pdf Exam Questions Dumps at below page. You can use our Cisco certprepare 300 115 braindumps and pass your exam.

Q21. After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?

A. The switches are using mismatched EtherChannel negotiation modes.

B. The switch ports are not configured in trunking mode.

C. LACP priority must be configured on both switches.

D. The channel group identifier must be different for Switch A and Switch B.

Answer: A

Q22. A Cisco Catalyst switch that is prone to reboots continues to rebuild the DHCP snooping database. What is the solution to avoid the snooping database from being rebuilt after every device reboot?

A. A DHCP snooping database agent should be configured.

B. Enable DHCP snooping for all VLANs that are associated with the switch.

C. Disable Option 82 for DHCP data insertion.

D. Use IP Source Guard to protect the DHCP binding table entries from being lost upon rebooting.

E. Apply ip dhcp snooping trust on all interfaces with dynamic addresses.

Answer: A

Q23. A network engineer has just deployed a non-Cisco device in the network and wants to get information about it from a connected device. Cisco Discovery Protocol is not supported, so the open standard protocol must be configured. Which protocol does the network engineer configure on both devices to accomplish this?

A. IRDP

B. LLDP

C. NDP

D. LLTD

Answer: B

Q24. The network manager has requested that several new VLANs (VLAN 10, 20, and 30) are allowed to traverse the switch trunk interface. After the command switchport trunk allowed vlan 10,20,30 is issued, all other existing VLANs no longer pass traffic over the trunk. What is the root cause of the problem?

A. The command effectively removed all other working VLANs and replaced them with the new VLANs.

B. VTP pruning removed all unused VLANs.

C. ISL was unable to encapsulate more than the already permitted VLANs across the trunk.

D. Allowing additional VLANs across the trunk introduced a loop in the network.

Answer: A

Q25. Which command does a network engineer use to verify the spanning-tree status for VLAN 10?

A. switch# show spanning-tree vlan 10

B. switch# show spanning-tree bridge

C. switch# show spanning-tree brief

D. switch# show spanning-tree summary

E. switch# show spanning-tree vlan 10 brief

Answer: A

Q26. which statement about the use of PAgP link aggregation on a Cisco switch that is running Cisco IOS Software is true?

A. PAgP modes are off, auto, desirable, and on. Only the combinations auto-desirable, desirable-desirable, and on-on allow the formation of a channel.

B. PAgP modes are active, desirable, and on. Only the combinations active-desirable, desirable-desirable, and on-on allow the formation of a channel.

C. PAgP modes are active, desirable, and on. Only the combinations active-active, desirable-desirable, and on-on allow the formation of a channel.

D. PAgP modes are off, active, desirable, and on. Only the combinations auto-auto, desirable-desirable, and on-on allow the formation of a channel.

Answer: A

Q27. Which statement describes what happens when a port configured with root guard receives a superior BPDU?

A. The port goes into errdisabled state and stops forwarding traffic.

B. The port goes into BPDU-inconsistent state and stops forwarding traffic.

C. The port goes into loop-inconsistent state and stops forwarding traffic.

D. The port goes into root-inconsistent state and stops forwarding traffic.

Answer: D

Q28. Which configuration command ties the router hot standby priority to the availability of its interfaces?

A. standby group

B. standby priority

C. backup interface

D. standby track

Answer: D

Q29. Which statement describes what happens when a switch enters dual active recovery mode?

A. The switch shuts down and waits for the VSL link to be restored before sending traffic.

B. All interfaces are shut down in the formerly active virtual switch member, but the new active virtual switch forwards traffic on all links.

C. The switch continues to forward traffic out all links and enables spanning tree on VSL link and all other links to prevent loops.

D. The VSS detects which system was last in active state and shuts down the other switch.

Answer: B

Q30. What is the default value for the errdisable recovery interval in a Cisco switch?

A. 30 seconds

B. 100 seconds

C. 300 seconds

D. 600 seconds

Answer: C