300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Master the 300 115 vce Implementing Cisco IP Switched Networks content and be ready for exam day success quickly with this Ucertify 9tut ccnp switch 300 115 exam fees. We guarantee it!We make it a reality and give you real ccnp switch 300 115 dumps pdf questions in our Cisco cbt nuggets ccnp switch 300 115 download braindumps.Latest 100% VALID Cisco ccnp switch 300 115 Exam Questions Dumps at below page. You can use our Cisco 300 115 dumps braindumps and pass your exam.

Q31. Which technique automatically limits VLAN traffic to only the switches that require it?

A. access lists

B. DTP in nonegotiate

C. VTP pruning

D. PBR

Answer: C

Q32. Refer to the exhibit.

The users in an engineering department that connect to the same access switch cannot access the network. The network engineer found that the engineering VLAN is missing from the database. Which action resolves this problem?

A. Disable VTP pruning and disable 802.1q.

B. Update the VTP revision number.

C. Change VTP mode to server and enable 802.1q.

D. Enable VTP pruning and disable 802.1q.

Answer: C

Q33. An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?

A. Enable Cisco Express Forwarding to allow for more effective traffic sharing over the EtherChannel bundle.

B. Adjust the EtherChannel load-balancing method based on destination IP addresses.

C. Disable spanning tree on all interfaces that are participating in the EtherChannel bundle.

D. Use link-state tracking to allow for improved load balancing of traffic upon link failure to the server.

E. Adjust the EtherChannel load-balancing method based on source IP addresses.

Answer: E

Q34. Refer to the exhibit.

What is the result of the SPAN configuration on a Cisco switch?

A. Configure a SPAN session to monitor the received traffic on interface g0/4 only for VLAN 3.

B. Configure a SPAN session to monitor the received traffic on interface g0/4 for all VLANs except VLAN 3.

C. Configure a SPAN session to monitor the received traffic on interface g0/5 only for VLAN 3.

D. Configure a SPAN session to monitor the received traffic on interface g0/5 for all VLANs except VLAN 3.

Answer: A

Q35. Which VTP mode is needed to configure an extended VLAN, when a switch is configured to use VTP versions 1 or 2?

A. transparent

B. client

C. server

D. Extended VLANs are only supported in version 3 and not in versions 1 or 2.

Answer: D

Q36. A network engineer wants to add a new switch to an existing switch stack. Which configuration must be added to the new switch before it can be added to the switch stack?

A. No configuration must be added.

B. stack ID

C. IP address

D. VLAN information

E. VTP information

Answer: A

Q37. On which interface can port security be configured?

A. static trunk ports

B. destination port for SPAN

C. EtherChannel port group

D. dynamic access point

Answer: A

Q38. Which command globally enables AAA on a device?

A. aaa new-model

B. aaa authentication

C. aaa authorization

D. aaa accounting

Answer: A

Q39. When you design a switched network using VTPv2, how many VLANs can be used to carry user traffic?

A. 1000

B. 1001

C. 1024

D. 2048

E. 4095

F. 4096

Answer: B

Q40. While troubleshooting a network outage, a network engineer discovered an unusually high level of broadcast traffic coming from one of the switch interfaces. Which option decreases consumption of bandwidth used by broadcast traffic?

A. storm control

B. SDM routing

C. Cisco IOS parser

D. integrated routing and bridging

E. Dynamic ARP Inspection

Answer: A