300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Master the cbt nuggets ccnp switch 300 115 download Implementing Cisco IP Switched Networks content and be ready for exam day success quickly with this Pass4sure cbt nuggets ccnp switch 300 115 download vce. We guarantee it!We make it a reality and give you real cbt nuggets ccnp switch 300 115 download questions in our Cisco 300 115 switch braindumps.Latest 100% VALID Cisco ccnp 300 115 Exam Questions Dumps at below page. You can use our Cisco ccnp routing and switching switch 300 115 official cert guide braindumps and pass your exam.

Q11. Refer to the exhibit.

Users of PC-1 experience slow connection when a webpage is requested from the server. To increase bandwidth, the network engineer configured an EtherChannel on interfaces Fa1/0 and Fa0/1 of the server farm switch, as shown here:

Server_Switch#sh etherchannel load-balance EtherChannel Load-Balancing Operational State (src-mac): Non-IP: Source MAC address

IPv4: Source MAC address IPv6: Source IP address Server_Switch#

However, traffic is still slow. Which action can the engineer take to resolve this issue?

A. Disable EtherChannel load balancing.

B. Upgrade the switch IOS to IP services image.

C. Change the load-balance method to dst-mac.

D. Contact Cisco TAC to report a bug on the switch.

Answer: C

Q12. Several new switches have been added to the existing network as VTP clients. All of the new switches have been configured with the same VTP domain, password, and version. However, VLANs are not passing from the VTP server (existing network) to the VTP clients. What must be done to fix this?

A. Remove the VTP domain name from all switches with "null" and then replace it with the new domain name.

B. Configure a different native VLAN on all new switches that are configured as VTP clients.

C. Provision one of the new switches to be the VTP server and duplicate information from the existing network.

D. Ensure that all switch interconnects are configured as trunks to allow VTP information to be transferred.

Answer: D

Q13. What is required for a LAN switch to support 802.1q Q-in-Q encapsulation?

A. Support less than 1500 MTU

B. Support 1504 MTU or higher

C. Support 1522 layer 3 IP and IPX packet

D. Support 1547 MTU only

Answer: B

Q14. Refer to the exhibit.

A multilayer switch has been configured to send and receive encapsulated and tagged frames. VLAN 2013 on the multilayer switch is configured as the native VLAN. Which option is the cause of the spanning-tree error?

A. VLAN spanning-tree in SW-2 is configured.

B. spanning-tree bpdu-filter is enabled.

C. 802.1q trunks are on both sides, both with native VLAN mismatch.

D. VLAN ID 1 should not be used for management traffic because its unsafe.

Answer: C

Q15. A network engineer must improve bandwidth and resource utilization on the switches by stopping the inefficient flooding of frames on trunk ports where the frames are not needed. Which Cisco IOS feature can be used to achieve this task?

A. VTP pruning

B. access list

C. switchport trunk allowed VLAN

D. VLAN access-map

Answer: A

Q16. Which option describes a limitation of LLDP?

A. LLDP cannot provide information about VTP.

B. LLDP does not support TLVs.

C. LLDP can discover only Windows servers.

D. LLDP can discover up to two devices per port.

Answer: A

Q17. A network engineer configured an Ethernet switch using these commands. Switchone(config) # Spanning-tree portfast bpdufilter default

Which statement about the spanning-tree portfast feature on the switch is true?

A. If an interface is enabled for portfast receives BDPU, the port goes through the spanning-tree listening, learning, and forwarding states.

B. If an interface is enabled for portfast receives BDPU, the port does not go through the spanning-tree listening, learning, and forwarding states.

C. If an interface is enabled for portfast receives BDPU, the port is shut down immediately.

D. If an interface is enabled for portfast receives BDPU, the port goes into the spanning- tree inconsistent state.

Answer: A

Q18. What is the maximum number of VLANs that can be assigned to an access switchport without a voice VLAN?

A. 0

B. 1

C. 2

D. 1024

Answer: B

Q19. Which switch feature prevents traffic on a LAN from being overwhelmed by continuous multicast or broadcast traffic?

A. storm control

B. port security

C. VTP pruning

D. VLAN trunking

Answer: A

Q20. A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?

A. The routers are connected via a Layer 2 switch.

B. IP routing is disabled on neighboring devices.

C. Cisco Express Forwarding is enabled locally.

D. Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.

Answer: A