300-115 Exam Questions - Online Test

300-115 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

Want to know Actualtests 300 115 switch Exam practice test features? Want to lear more about Cisco Implementing Cisco IP Switched Networks certification experience? Study Best Quality Cisco examcollection 300 115 answers to Improved 9tut ccnp switch 300 115 questions at Actualtests. Gat a success with an absolute guarantee to pass Cisco ccnp switch 300 115 (Implementing Cisco IP Switched Networks) test on your first attempt.

Q51. Refer to the exhibit.

A network engineer investigates a recent network failure and notices that one of the interfaces on the switch is still down. What is causing the line protocol on this interface to be shown as down?

A. There is a layer 1 physical issue.

B. There is a speed mismatch on the interface.

C. The interface is configured as the target of the SPAN session.

D. The interface is configured as the source of the SPAN session.

E. There is a duplex mismatch on the interface.

Answer: C

Q52. What is the maximum number of virtual MAC addresses that GLBP allows per group?

A. 2

B. 4

C. 6

D. 8

Answer: B

Q53. A network engineer configures port security and 802.1x on the same interface. Which option describes what this configuration allows?

A. It allows port security to secure the MAC address that 802.1x authenticates.

B. It allows port security to secure the IP address that 802.1x authenticates.

C. It allows 802.1x to secure the MAC address that port security authenticates.

D. It allows 802.1x to secure the IP address that port security authenticates.

Answer: A

Q54. After reviewing UDLD status on switch ports, an engineer notices that the." Which statement describes what this indicates about the status of the port?

A. The port is fully operational and no known issues are detected.

B. The bidirectional status of "unknown" indicates that the port will go into the disabled state because it stopped receiving UDLD packets from its neighbor.

C. UDLD moved into aggressive mode after inconsistent acknowledgements were detected.

D. The UDLD port is placed in the "unknown" state for 5 seconds until the next UDLD packet is received on the interface.

Answer: A

Q55. Which authentication service is needed to configure 802.1x?

A. RADIUS with EAP Extension

B. TACACS+

C. RADIUS with CoA

D. RADIUS using VSA

Answer: A

Q56. Refer to the exhibit.

A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination

B. A remote SPAN VLAN on the distribution and access layer switch

C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination

D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination

E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination

F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

Answer: BCD

Q57. after UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?

A. Normal UDLD operations that prevent traffic loops.

B. UDLD port is configured in aggressive mode.

C. UDLD is enabled globally.

D. UDLD timers are inconsistent.

Answer: B

Q58. A network engineer wants to ensure Layer 2 isolation of customer traffic using a private VLAN. Which configuration must be made before the private VLAN is configured?

A. Disable VTP and manually assign VLANs.

B. Ensure all switches are configured as VTP server mode.

C. Configure VTP Transparent Mode.

D. Enable VTP version 3.

Answer: C

Q59. Which option is a possible cause for an errdisabled interface?

A. routing loop

B. cable unplugged

C. STP loop guard

D. security violation

Answer: D

Q60. Which statement about Cisco devices learning about each other through Cisco Discovery Protocol is true?

A. Each device sends periodic advertisements to multicast address 01:00:0C:CC:CC:CC.

B. Each device broadcasts periodic advertisements to all of its neighbors.

C. Each device sends periodic advertisements to a central device that builds the network topology.

D. Each device sends periodic advertisements to all IP addresses in its ARP table.

Answer: A