NEW QUESTION 1
When R2 forwards data to R3 from R1, which of the following items will change?(Choose two)

• A. The source MAC address
• B. The destination MAC address
• C. The source IP address
• D. The destination IP address

Answer: AB

NEW QUESTION 2
Refer to the graphic. RTA and RTB are connected over a Frame Relay network using a DLCI, as shown. Staticmapping is required on RTA. Which of the following commands will achieve this?

• A. [RTA-Serial1/0/1]fr map ip 172.16.1.1 30
• B. [RTA-Serial1/0/1]fr map ip 172.16.1.1 31
• C. [RTA-Serial1/0/1]fr map ip 172.16.2.1 30
• D. [RTA-Serial1/0/1]fr map ip 172.16.2.1 31

Answer: C

NEW QUESTION 3
Which of the following parameter settings for terminal emulation are correct when configuring a Huawei routerthrough the Console port?

• A. 4800bps, 8 data bits,1 stop bits, odd parity check, and no flow control
• B. 9600bps, 8 data bits, 1 stop bits, no parity check, and no flow control
• C. 9600bps, 8 data bits, 1 stop bits, even parity check, and hardware flow control
• D. 19200bps, 8 data bits, 1 stop bits, no parity check, and no flow control

Answer: B

NEW QUESTION 4
An OSPF area is a collection of a group of routers and networks. OSPF defines that routers that have thesame ( ) belong to the same OSPF area.

• A. neighbors
• B. LSDB
• C. LSA
• D. adjacency

Answer: B

NEW QUESTION 5
After a command for displaying RIP route information is entered on a router, peer 192.168.1.2 on Serial1/0/0 isdisplayed in the returned result. What does 192.168.1.2 stand for?

• A. Address of a RIP neighbor
• B. Address of the port with the RIP protocol enabled
• C. Next hop address of the RIP route
• D. Transmission address of the RIP protocol

Answer: A

NEW QUESTION 6
Which of the following authentication methods are supported for Telnet users?(Choose three)

• A. Password authentication
• B. AAA local authentication
• C. MD5 authentication
• D. No authentication

Answer: ABD

NEW QUESTION 7
Which command should be used to check the mapping between protocol addresses and frame relayaddresses?

• A. display fr interface
• B. display fr map-info
• C. display fr inarp-info
• D. display interface brief

Answer: B

NEW QUESTION 8
Which of the following formats represent an accurate condensing of the IPv6 address2031:0000:720C:0000:0000:09E0:839A:130B?(Choose two).

• A. 2031:0:720C:0:0:9E0:839A:130B
• B. 2031:0:720C:0:0:9E:839A:130B
• C. 2031::720C::9E0:839A:130B
• D. 2031:0:720C::9E0:839A:130B

Answer: AD

NEW QUESTION 9
<Huawei>
Warning: Auto-Config is working. Before configuring the device, stop Auto-Config. If you perform configurationswhen Auto-Config is running, the DHCP, routing, DNS, and VTY configurations will be lost. Do you want tostop Auto-Config? [y/n]:
Refer to the output. When the administrator first starts the router, a system notice is displayed, however afterrebooting this router, the notice disappeared. What is the reason for this?(Choose two)

• A. This notice only appears during the very first device startup.
• B. The administrator has configured the device and saved the configuration, causing the notice to disappear.
• C. The administrator selected ‘n’ and did not save the configuration
• D. The administrator selected ‘y’ and saved the configuration.

Answer: BD

NEW QUESTION 10
Which of the following statements regarding static and dynamic routing is incorrect?

• A. The static route can be easily configured and managed on the enterprise network.
• B. The use of dynamic routing is more convenient for the administrator to manage the network following network convergence.
• C. The static route can automatically recover when a link failure is encountered.
• D. Dynamic routing will use more resources than static routes.

Answer: C

NEW QUESTION 11
A user accesses a server supporting AAA, for which the authorization mode on the AAA server has beenconfigured using the command “authorization-mode hwtacacs if- authenticated”. Which of the followingstatements regarding this command are true?(Choose three).

• A. If the hwtacacs server fails to respond, the user will be authenticated using local authentication.
• B. If the hwtacacs server fails to respond, the user will be authenticated using remote authentication.
• C. If the hwtacacs server fails to respond, the user will bypass authentication.
• D. The hwtacacs server will authorize the user.

Answer: ABD

NEW QUESTION 12
In port aggregation, “multiple” ports are aggregated to form a port aggregation group so that all the memberports in the group share the outgoing/incoming load. At which layer is port aggregation implemented?

• A. Physical Layer
• B. Data Link Layer
• C. Network Layer
• D. Transport Layer

Answer: B

NEW QUESTION 13
Which authentication modes does AAA support?(Choose three).

• A. None
• B. Local
• C. Radius
• D. 802.1X

Answer: ABC

NEW QUESTION 14
Which of the following technologies can allow a host with IP address 10.0.0.1 to access the internet?

• A. Static route
• B. Dynamic route
• C. Route import
• D. NAT

Answer: D

NEW QUESTION 15
An administrator wishes to manage the router in the remote branch office, which method can be used?

• A. Telnet
• B. FTP
• C. Console Connection
• D. DHCP

Answer: A

NEW QUESTION 16
The administrator wishes to update the configuration file of an AR2200 router using a USB
cable. How can thisbe achieved?(Choose two)

• A. The administrator should connect the USB cable between the terminal and the mini USB port of the AR2200router.
• B. The administrator should connect the USB cable between the terminal and the USB port of the AR2200router.
• C. The AR2200 router cannot support configuration updates through a USB cable.
• D. The administrator should install the mini USB drivers on the terminal after connecting the USB.

Answer: AD

NEW QUESTION 17
When using VRP, which of the following commands is used to configure the data link layer encapsulation typeof a serial interface as HDLC?

• A. encapsulation hdlc
• B. link-protocol hdlc
• C. hdlc enable
• D. link-protocol ppp

Answer: B

NEW QUESTION 18
Which of the following methods are supported by VRP platform to configure the router?(Choose three)

• A. Through the Console port
• B. Through Telnet
• C. Through the AUX port
• D. Through FTP

Answer: ABC

NEW QUESTION 19
Two routers are connected via serial interfaces, for which the link-protocol is PPP. The network administratorwishes to configure PPP authentication to improve security on this link. Which PPP authentication methodprovides a more secure solution?

• A. CHAP
• B. PAP
• C. MD5
• D. SSH

Answer: A