NEW QUESTION 1
Which of the following protocols is used in Frame Relay to map the address to DLCI dynamically?
<choice ident="A">
<choice ident="B">
<choice ident="C">
<choice ident="D">

• A. ARP protocol
• B. RARP protocol
• C. InARP protocol
• D. Map protocol

Answer: C

NEW QUESTION 2
Refer to the graphic. The network administrator has configured ACL 2000 to filter packets on RTA, as shown.
Which of following statements regarding the subsequent behavior are correct?(Choose two).

• A. RTA will forward packets received from Host A.
• B. RTA will drop packets received from Host A.
• C. RTA will forward packets received from Host B.
• D. RTA will drop packets received from Host B.

Answer: BC

NEW QUESTION 3
Two routers are connected via serial interfaces and the link-protocol is PPP, but the MRU of two serialinterface’s are different, in PPP LCP negotiated stage, what will happen?

• A. LCP negotiation will fail
• B. Negotiation will use the smaller value
• C. Negotiation will use the larger value
• D. Negotiation will use 1500

Answer: B

NEW QUESTION 4
The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards framesbased on which of the following parameters?

• A. The same source or destination IP address
• B. The same source or destination MAC address.
• C. The same protocol type.
• D. The same source or destination port number.

Answer: AB

NEW QUESTION 5
According to the default value of route preference on the VRP platform, which of the following represent thecorrect sequence for direct route, static route, RIP and OSPF if they are listed from high preference to lowpreference?

• A. Direct, Static, RIP, OSPF
• B. Direct, OSPF, Static, RIP
• C. Direct, OSPF, RIP, Static
• D. Direct, RIP, Static, OSPF

Answer: B

NEW QUESTION 6
A network administrator recently used tracert to trace the path to the destination IP address of an externalwebsite, however the trace path displayed only a timeout result. Which of the following statements correctlyexplains the reason for this?(Choose two)

• A. The source router had shutdown the ICMP function.
• B. This destination IP address does not exist.
• C. The gateway canot find a route to the destination.
• D. This is a normal phenomenon.

Answer: BC

NEW QUESTION 7
An administrator discovered he/she was unable to use TFTP to transfer files to the router.
Which of thefollowing describes the likely reason for this?

• A. The TFTP service had been disabled on the router.
• B. TCP port 69 of the server had been blocked.
• C. UDP port 69 of the server had been blocked.
• D. The username and password had been modified.

Answer: C

NEW QUESTION 8
Refer to the graphic. RTA and RTB are running RIPv1. RTA has advertised 10.0.0.0 and 192.168.1.0 to theRIP network. Which routes will exist in the IP routing table of RTB?(Choose two)

• A. 10.0.0.0/8
• B. 192.168.1.1/32
• C. 10.1.12.1/32
• D. 192.168.1.0/24

Answer: CD

NEW QUESTION 9
Which of the following commands is used to enable dynamic address mapping protocol in the interfaceencapsulated with Frame Relay?

• A. fr inarp
• B. fr reverse-arp
• C. inverse-arp
• D. reverse-arp

Answer: A

NEW QUESTION 10
How many probe packets are sent for each TTL value by default when"tracert" is used to detect the path alongwhich packet is sent from source to destination?

• A. 3
• B. 4
• C. 6
• D. 8

Answer: A

NEW QUESTION 11
An AR2200 router in the company network cannot boot. In order to resolve this, the administrator wishes toupdate the VRP software. What should he/she do?

• A. The administrator should use a console cable to connect the router and host, and directly upgrade thedevice.
• B. The administrator should use FTP to transfer the VRP software, by configuring the AR2200 router as anFTP client.
• C. The administrator should use DHCP to boot the AR2200, and then use the AR2200 router as a TFTP clientto download the VRP software from the server.
• D. The administrator should use the telnet command on the client to remote access the device, and upgradethe VRP software.

Answer: B

NEW QUESTION 12
<Huawei> system-view
[Huawei]command-privilege level 3 view user save
Refer to the command output. What is the result of the shown command?

• A. The command adjusts the save command of a user to privilege level 3.
• B. The command adjusts the save command in the user view to privilege level 3.
• C. The command adjusts the user view command privilege level to 3, and saves the configuration.
• D. The command adjusts the privilege level of a user to 3, and saves the configuration.

Answer: B

NEW QUESTION 13
The administrator uses the ping command on the host to test connectivity to the website www.huawei.com.
The command line shows a request time out. The administrator displays the ARP entries for the host.
Which entry will be found in the ARP cache table of the host?

• A. The MAC address of the destination www.huawei.com will exist in the ARP cache.
• B. The MAC address of the switch will exist in the ARP cache.
• C. The IP address of the destination www.huawei.com will exist in the ARP cache.
• D. The MAC address of router interface G0/0/0, will exist in the ARP cache.

Answer: D

NEW QUESTION 14
To provide the information about the IP addresses that a user packet traverses along the path to thedestination, which of the following does Tracert record in each expired ICMP TTL packet?

• A. Destination port
• B. Source port
• C. Destination address
• D. Source address

Answer: D

NEW QUESTION 15
<R2>debugging rip 1
Sep 13 2013 11:07:20.974.1-05:13 R2 RIP/7/DBG: 6: 13414: RIP 1: Receiving v1 response
on
GigabitEthernet0/0/0 from 10.0.12.1 with 1 RTE
Sep 13 2013 11:07:20.974.2-05:13 R2 RIP/7/DBG: 6: 13465: RIP 1: Receive response
from 10.0.12.1 on GigabitEthernet0/0/0
Sep 13 2013 11:07:20.974.3-05:13 R2 RIP/7/DBG: 6: 13476: Packet: Version 1, Cmd
response, Length 24
Sep 13 2013 11:07:20.974.4-05:13 R2 RIP/7/DBG: 6: 13527: Dest 1.0.0.0, Cost 1
Sep 13 2013 11:07:20.974.5-05:13 R2 RIP/7/DBG: 6: 2688: RIP 1: Ignoring packet. This
version is notconfigured.
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not asexpected and performs debugging. Based on the output from the debug, what is the source of the problem?

• A. R2 has configured an ACL to block the route to network 1.0.0.0
• B. R2 has enabled split horizon.
• C. R1 is using authentication, however R2 is not.
• D. R2 is operating using RIPv2, while R1 is using RIPv1.

Answer: D

NEW QUESTION 16
Refer to the graphic. RTA is a DTE device connected to a Frame Relay switch, and uses
dynamic addressmapping to establish the PVC. With regards to the configuration, which of the following commands are notnecessary?(Choose two).

• A. [RTA-Serial1/0/1]ip address 172.16.1.1 24
• B. [RTA-Serial1/0/1]link-protocol FR
• C. [RTA-Serial1/0/1]fr interface-type dte
• D. [RTA-Serial1/0/1]fr inarp

Answer: CD

NEW QUESTION 17
A layer 2 LAN switch generates CAM table entries according to the ( ) of the received frame.

• A. Source MAC address
• B. Destination MAC address
• C. Source IP address
• D. Destination IP address

Answer: A

NEW QUESTION 18
A web server in a private network is required to provide HTTP services to public users. The networkadministrator is required to configure NAT on RTA. Which configuration should be used?

• A. [RTA-Serial1/0/1]nat server protocol tcp global 202.10.10.1 www inside 192.168.1.1 8080
• B. [RTA-Serial0/0/1]nat server protocol tcp global 192.168.1.1 www inside 202.10.10.1 8080
• C. [RTA-Gigabitethernet0/0/1]nat server protocol tcp global 202.10.10.1 www inside 192.168.1.1 8080
• D. [RTA- Gigabitethernet0/0/1]nat server protocol tcp global 192.168.1.1 www inside 202.10.10.1 8080

Answer: A

NEW QUESTION 19
What will the destination MAC address be at the moment a frame is transmitted by the host, when the router isthe IP destination?

• A. The MAC address of the switch.
• B. The MAC address of the router interface G0/0/0.
• C. The MAC address of the host.
• D. The destination MAC address will be a broadcast MAC address.

Answer: D