NEW QUESTION 1
Which of the following commands is used to enter the system-view from the user view on a Huawei router?

• A. system-view
• B. enable
• C. configure terminal
• D. interface system

Answer: A

NEW QUESTION 2
What of the following statements is correct regarding access control list types and ranges?

• A. A basic ACL value ranges from 1000-2999
• B. An advanced ACL value ranges from 3000-4000
• C. A layer 2 ACL value ranges from 4000-4999
• D. An interface ACL value ranges 1000-2000

Answer: C

NEW QUESTION 3
Which of the following statements regarding the DR in an OSPF network are correct?(Choose two)

• A. There must be at least one DR in an OSPF area.
• B. A DR must be elected among the routers through the negotiations that are defined by OSPF protocol.
• C. Only the router with highest priority will be elected as DR.
• D. Only NBMA or Broadcast networks need to elect DR

Answer: BD

NEW QUESTION 4
On VRP platform, which of the following parameters can be used together with the "ping" command to specifythe source address of an echo request message?

• A. A
• B. S
• C. D
• D. N

Answer: A

NEW QUESTION 5
When using VRP, which of the following commands is used to configure the PPP authentication method asPAP?

• A. ppp pap
• B. ppp authentication-pap
• C. ppp authentication-mode pap
• D. ppp pap-authentication

Answer: C

NEW QUESTION 6
<Huawei>system-view
[Huawei]history-command max-size 20
Refer to the command output. Which statements regarding the shown command are true?(Choose two)

• A. The command is used to adjust the size of the history command buffer
• B. The default value of the history command buffer is 5.
• C. The command should be configured in the user-interface view.
• D. Once configured, commands totalling up to 20 bytes can be saved in the buffer.

Answer: AC

NEW QUESTION 7
Refer to the graphic. R1,R2 and R3 are running RIPv1. R1 and R3 both advertise 172.16.0.0 to the RIPnetwork. How will this affect R2?

• A. R2 will not have a route to the networks 172.16.1.0/24 and 172.16.2.0/24
• B. R2 will only have a route to 172.16.1.0/24
• C. R2 will only have a route to 172.16.2.0/24
• D. R2 will have a route to both networks 172.16.1.0/24 and 172.16.2.0/24, but some packets for these destinations will be lost.

Answer: D

NEW QUESTION 8
If PPP authentication fails, which type of packet will be sent to the authenticated peer by the authenticator?

• A. Authenticate-Ack
• B. Authenticate-Nak
• C. Authenticate-Reject
• D. Authenticate-Reply

Answer: B

NEW QUESTION 9
On VRP platform, the command lines are classified into four levels in increasing priority: Visit level, Monitoringlevel, Configuration level, and Management level. At which level, the operator is permitted to configure servicebut is not permitted to operate the file system?

• A. Visit level
• B. Monitoring level
• C. Configuration level
• D. Management level

Answer: C

NEW QUESTION 10
An AR2200 router is required to be reconfigured from scratch. Which steps are needed to achieve this?(Choose two)

• A. Reset the saved configuration
• B. Clear the current configuration
• C. Reboot the AR2200.
• D. Assign the configuration file to be used at next startup.

Answer: AC

NEW QUESTION 11
The network administrator wants to improve the performance of network transmission, what steps can theadministrator take?(Choose two)

• A. Change the work mode to full duplex of each end station.
• B. Link the end stations together using a switch.
• C. Change the work mode to half duplex of each end station.
• D. Link the end stations together using a hub.

Answer: AB

NEW QUESTION 12
The IP addresses of clients in the network are deployed via a DHCP server. When a host reboots, whichmessage will the host first send to the DHCP server?

• A. DHCP DISCOVER
• B. DHCP REQUEST
• C. DHCP OFFER
• D. DHCP ACK

Answer: B

NEW QUESTION 13
[RTA]acl 2002
[RTA-acl-basic-2002]rule permit source 20.1.1.1 0
[RTA-acl-basic-2002]rule permit source 30.1.1.1 0
Refer to the configuration output. A network administrator configured the ACL on router
RTA, as shown. Whichof the following statements regarding the rule order are correct?(Choose two).

• A. The rule-number of the first rule is 1
• B. The rule-number of the first rule is 5
• C. The rule-number of the second rule is 2
• D. The rule-number of the second rule is 10

Answer: BD

NEW QUESTION 14
Refer to the graphic. Two peering routers are running RIP. RTA is using RIPv1 to advertise its routes, whileRTB is using RIPv2 to advertise the route 1.1.1.1/32. How will the route 1.1.1.1/32 appear in the IP routingtable of RTA?

• A. This route will not appear in the IP routing table of RTA.
• B. This route will appear in the IP routing table of RTA as 1.0.0.0/8.
• C. This route will appear in the IP routing table of RTA as 1.0.0.0/24.
• D. This route will appear in the IP routing table of RTA as 1.0.0.0/32.

Answer: D

NEW QUESTION 15
Destination/Mask protocol pre Cost Nexthop Interface
9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial 1/0/0
9.1.0.0/16 RIP 100 5 2.2.2.2 Ethernet 0/0/1
Refer to the graphic. Which of the following statements is correct when this router forwards the packet to thedestination host 9.1.4.5?

• A. The router selects the first entry to match the destination address of the packet because the preference ofOSPF is higher than the preference of RIP.
• B. The router selects the second entry to match the destination address of the packet because the cost of RIPis lower than that of OSPF.
• C. The router selects the second entry to match the destination address of the packetbecause the outgoinginterface is an Ethernet interfac
• D. The forwarding speed of an Ethernet interface is faster than theforwarding speed of a serial interface
• E. The router selects the second entry to match the destination address of the packet because the router willmatch the most specific address.

Answer: D

NEW QUESTION 16
Which of the following types can ICMP packets be classified into?(Choose two)

• A. ICMP transport packet
• B. ICMP error reporting packet
• C. ICMP query packet
• D. ICMP application packet

Answer: BC

NEW QUESTION 17
<Quidway>display mac-address
-------------------------------------------------------------------------------
MAC Address VLAN/VSI Learned-From Type
-------------------------------------------------------------------------------
5489-98ec-f018 1/- GE0/0/13 dynamic
-------------------------------------------------------------------------------
Total items displayed = 1
Refer to the graphic. A switch attempts to forward a frame to the MAC destination 5489- 98ec-f01. Whatoperation will occur on the switch?

• A. The switch will send a request to obtain the MAC address of 5489-98ec-f011.
• B. The switch will report that the destination is unreachable and report this to the source.
• C. The switch will flood the frame via all ports, with exception of the port on which the frame was received.
• D. The switch will drop the frame because it does not have an entry in its MAC address table.

Answer: C

NEW QUESTION 18
The users who log on the router through Telnet are not permitted to configure IP address. What is the possiblereason?

• A. Communication failures occur between the user and the router.
• B. The authentication mode of Telnet is set incorrectly.
• C. Privilege level of Telnet is set incorrectly.
• D. SNMP parameters are set incorrectly.

Answer: C

NEW QUESTION 19
Which of the following statements about collision domains and broadcast domains are correct?(Choose three)

• A. Devices connected to the same hub form a collision domain
• B. Devices connected to the same hub form a broadcast domain
• C. Devices connected to the same bridge form a collision domain
• D. Devices connected to the same bridge form a broadcast domain
• E. Devices connected to the same router form a broadcast domain

Answer: ABD