NEW QUESTION 1
Refer to exhibit.

Which two statements about this command are true? (Choose two)

• A. The command is usually used FCIP over the overlay
• B. The command is used to extend the spanning tree for VLAN 72 across the overlay
• C. The command is used to enable unknown unicast flooding for a known MAC address across the overlay
• D. The command is used in HSRP localization for OTV
• E. The command is usually used for Microsoft network load balancing implementation

Answer: CE

NEW QUESTION 2
Which two statements about the dynamic load balancer mode in ACI are true? (Choose two)?

• A. The default DLB mode is “conservative”
• B. The aggressive DLB mode has a longer flowlet timeout interval
• C. The aggressive mode flowlettimeaut is a relatively higher value
• D. DLB adjusts the traffic allocations according to congestion levels
• E. The aggressive DLB mode has a shorter flowlet timeout interval

Answer: DE

NEW QUESTION 3
Which description of a hybrid SDN framework is true?

• A. The control plane function is split between a SDN controller and the networking element
• B. The control plane and data plane are pulled from the networking element and put in an SDN controller and SDN agent
• C. The data plane is pulled from the networking element and put in an SDN controller
• D. The control plane is pulled from networking element and put in an SDN controller

Answer: A

NEW QUESTION 4
Which two statements about OpenStack are true? (Choose two)

• A. Nova is the compute component that is used to manage and automate the provisioning ofcompute resources
• B. horizon is the component that is used for IP address management
• C. Keystone is the networking component that is used to create and manage network resources
• D. how is the GUI web application that is used to control and configure different OpenStackcomponents
• E. neutron is the networking component that is used to create and manage networkresources

Answer: AE

NEW QUESTION 5
When deploying a sensor network that uses CoAP, which of the following must be done on thefirewall to allow sensor traffic into the data center?

• A. Enable NAT64
• B. Permit IP Option 135 traffic from the sensor IP address range(s)
• C. Permit UDP traffic from the sensor IP address range
• D. Configure stateful inspection for ROLL

Answer: C

NEW QUESTION 6
Refer to the exhibit.

Which two features are enabled on the upstream switch? (Choose two)

• A. feature fcoe-npv
• B. feature npv
• C. feature fport-channel-trunk
• D. feature npiv
• E. feature fcoe

Answer: CD

NEW QUESTION 7
You configured a Cisco usNIC connectivity policy, for a HPC environment. Which action also must be completed?

• A. Download and compile the ring_c application
• B. Install the Intel MPI library environment
• C. Mount the MPI adapter in the operating system
• D. Install an MPI environment in the operating system

Answer: A

NEW QUESTION 8
Which three descriptions of the advantages of using a Layer 4 – Layer 7 service graph in the ACI Fabric are true? (Choose three)

• A. It provides a template that can be reused multiple times
• B. Only virtual Layer 4 – Layer 7 devices are required
• C. It makes manual VLAN assignments
• D. It automatically connects vNICs
• E. No contracts are required between consumer and provider EPGs
• F. It updates ACLs and pools automatically with endpoint discovery

Answer: ADF

Explanation: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/ACI_Best_Practices/b_ACI_Best_Practices/b_ACI_Best_Practices_chapter_0110.pdf

NEW QUESTION 9
Refer to the exhibit.

Your application has a reduced health score.Upon inspection, you find a fault that impacts the health
score. The fault currently is in the soaking lifecycle stare. Which two options are possible next steps while in this state? (Choose two)

• A. Acknowledge the fault, which immediately clears it from the system
• B. Once the soaking timer expires the fault ceases and no change is expected in sevenitylevel.
• C. The condition ceases by itself and goes into the soaking-clearing state
• D. The condition ceases by itself and automatically clears the fault
• E. The soaking timer expires and moves to the Raised sevenitylevel

Answer: CE

NEW QUESTION 10
Which statement about enhanced zoning is true?

• A. It cannot move back to basic zoning from enhanced zoning without a clean wipe and restore of the switches in the fabric.
• B. It does not support fWWN-based membership in the standard interop mode (interop mode 1).
• C. It provides a vendor ID along with a vendor-specific type value to uniquely identify a member type.
• D. Changes to the zoning database and subsequent distribution require reactivation of the zone set.

Answer: C

NEW QUESTION 11
Which language is used to write Cloupia Script?

• A. Python
• B. Java
• C. JavaScript
• D. Cisco UCS Director Macro Language

Answer: C

NEW QUESTION 12
You want to move one of your leaf switches connecting to your ACI fabric to another rack.it will be
reconnected to the same fabric after the move. Which operations must you preform before the move?

• A. Decommission the switch and remove from the controller
• B. Decommission the switch
• C. Blacklist the ports
• D. Disable the interfaces

Answer: B

NEW QUESTION 13
Which three commands must be run to enable support of adapter-fexon an interface on a Cisco
Nexus Switch? (Choose three)

• A. switchport mode vntag
• B. feature-set adaper-fex
• C. feature-set virtualization
• D. feature fex
• E. feature adapter-fex
• F. switchport mode adapterfex

Answer: ACE

NEW QUESTION 14
Which option lists the cloud service model?

• A. Internet as a Service, Platform as a Service, and Software as a Service
• B. Internet as a Service, Product as a Service, and Storage as a Service
• C. Infrastructure as a Service, Platform as a Service, and Storage as a Service
• D. Infrastructure as a Service, Platform as a Service, and Software as a Service
• E. Internet as a Service, Platform as a Service, and Storage as a Service

Answer: D

NEW QUESTION 15
Which two statements about ASA and multicontext support in ACI are true? (Choose two)

• A. The application policy Infrastructure Controller creates the contexts in the USA
• B. The APIC must communicate with the system context and each virtual context.
• C. Multicontext support enables the same physical appliance to be experted to multiple tennats.
• D. With ASA, you cannot partition a single physical ASA into multiple virtual firewalls
• E. You can create multiple partitions with a virtual appliance, but the vNICs can be shared

Answer: BC

NEW QUESTION 16
While doing service insertion with vASA with route peering, which two parts must be configured?
(Choose two.)

• A. The path for interfaces must be specified when the L4-L7 device is created.
• B. The route peering profile must be specified when the L4-L7 Service Graph template is created.
• C. The VM name must be specified when the L4-L7 device is created.
• D. The chassis must be specified when the L4-L7 device is created.

Answer: AB

NEW QUESTION 17
Which programming language is used to write custom workflow code in Cisco UCS Director?

• A. Python
• B. Java script
• C. Java
• D. Bash script

Answer: B

NEW QUESTION 18
DRAG DROP
Drag and drop the MST Spanning Tree protocol standards from left onto the correct characteristics on the right.

Answer:

Explanation: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/layer2/configuration/guide/Cisco_Nexus_7000_Series_NX-OS_Layer_2_Switching_Configuration_Guide_Release_5-x_chapter8.html#con_1706067

NEW QUESTION 19
How do you manually configure a vNIC MAC address?

• A. Use the mac -address-table static command.
• B. Modify the dynamic vNIC connection policy.
• C. Use the set identity dynamic-mac command.
• D. Modify the adapter policy.

Answer: D