
we provide Simulation Cisco ccie 400 101 dumps exam guide which are the best for clearing passleader 400 101 test, and to get certified by Cisco CCIE Routing and Switching (v5.0). The ccie 400 101 Questions & Answers covers all the knowledge points of the real passleader 400 101 exam. Crack your Cisco 400 101 vce Exam with latest dumps, guaranteed!
P.S. Simulation 400-101 testing software are available on Google Drive, GET MORE: https://drive.google.com/open?id=1GGI_rFzsSx1M95iUGUrA8n3R9FtM_FJK
Question No: 15
Which three fields are part of a TCN BPDU? (choose three.)
A. protocol ID
B. version
C. type
D. max-age
E. flags
F. message age
Answer: A,B,C
Question No: 16
Refer to the exhibit.
If R1 and R2 are on the same network, what is the effect on the network when you apply the given configuration to R 1 and R2?
A. A symmetric routing occurs because the bandwidth and delay K value settings are mismatched.
B. The interface bandv.4dlh and delay settings adjust automatically to match the new metric
settings.
C. The neighbor adjacency between R1 and R2temporarily resets and then reestablishes itself.
D. R1 and R2 fail to form a neighbor adjacency.
Answer: D
Question No: 17
What is one requirement to support the IGMP proxy feature?
A. Devices on the unidirectional link must be in the same IP subnet.
B. Devices connected to a unidirectional link must disable Internet access.
C. IGMP snooping must be disabled.
D. PIM-DM must be enabled on all unidirectional links.
Answer: A
Question No: 18
Which option describes the effect of the command ip route vrf DMZ 192.168.0.0.255.255.0.0
172.16.5.5 global?
A. It creates a s1atic default route in the "lh1 DMZ, and the next hop is in the global routing table.
B. It creates a static route in the VRF DMZ for 192.168.0.0 255.255.0.0, and the next hop is in the
global routing table.
C. It creates a static route in the global routing table for 192.168.0.0 255.255.0.0, and the next hop
is in the global routing table.
D. It creates a s1atic route in the global routing for 192.168.0.0 255.255.0.0, and the next hop is in
The VRF DMZ.
E. lt creates a static route in the VRF DMZ for 192.168.0.0 255.255.0.0, and the next hop is in the
VRFDMZ.
Answer: B
Question No: 19
Which IPv6 tunneling mechanism requires a service provider to nude one of its own native IPv6 blocks to guarantee that its IPv6 hosts will be reachable?
A. 6rd tunneling
B. Automatic 6to4 tunneling
C. manual ipv6ip tunneling
D. NAT-PT tunneling
E. Automatic 4to6 tunneling
F. ISATAP tunneling
Answer: F
Question No: 20
Which action does route poising take that serves as a loop-prevention method?
A. It prohibits a router from advertising back onto the interface from which it was learned.
B. It immediately sends routing updates with an unreachable metric to all devices.
C. It poisons the route by tagging it uniquely within the network.
D. It advertises a route with an unreachable metric back onto the interface from which it was learned.
Answer: B
Question No: 21
Refer to the exhibit.
Routers A and B are the edge devices at two different sites such as shown.
'The two edge devices use public addresses on their WAN interfaces and the both sites use RFC
1918 for all other addresses. If routers A and B have established an IP sec tunnel, which statement
about the network environment must be true?
A. Router A1 and router 81 are using NAT translation to allow private-address traffic to traverse the tunnel.
B. Router A and router Bare using BGP to share routes between the two sites
C. The tunnel terminates on the ISP routes
D. Each site is capable of routing private addressing over the IPsec tunnel
Answer: D
Recommend!! Get the Simulation 400-101 dumps in VCE and PDF From Certleader, Welcome to download: https://www.certleader.com/400-101-dumps.html (New 911 Q&As Version)