NEW QUESTION 1
Which statement about the VideoStream/Multicast Direct feature is true?

• A. IP multicast traffic is reliable over WLAN by default as defined by the IEEE 802.11 wireless multicast delivery mechanism.
• B. Each VideoStream client acknowledges receiving a video IP multicast stream.
• C. It converts the unicast frame to a multicast frame over the air.
• D. It makes the delivery of the IP multicast stream less reliable over the air, but reliable over Ethernet.

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-1/configuration-guide/b_cg81/multicast_broadcast_setup.html

NEW QUESTION 2
An engineer wants the wireless voice traffic class of service to be used to determine the queue order for packets received, and then have the differentiated services code point set to match when it is resent to another port on the switch. Which configuration is required in the network?

• A. Platinum QoS configured on the WLAN
• B. WMM set to required on the WLAN
• C. msl qos trust dscp configured on the controller switch port
• D. msl qos trust cos configured on the controller switch port

Answer: C

NEW QUESTION 3
An engineer must use Cisco AVC on a Cisco WLC to prioritize Cisco IP cameras that use the wireless network. Which element do you configure in a rule?

• A. permit-ACL
• B. WMM required
• C. mark
• D. rate-limit

Answer: C

NEW QUESTION 4
What is an important consideration when implementing a dual SSID design for BYOD?

• A. After using the provisioning SSID, an ACL that used to make the client switch SSIDs forces the user to associate and traverse the network by MAC filtering.
• B. If multiple WLCs are used, the WLAN IDs must be exact for the clients to be provisioned and traverse the network correctly.
• C. SSIDs for this setup must be configured with NAC State-RADIUS NAC for the clients to authenticate with Cisco ISE, or with NAC State-ISE NAC for Cisco ISE to associate the client.
• D. One SSID is for provisioning and the other SSID is for gaining access to the networ
• E. The use of an ACL should not be enforced to make the client connect to the REAL SSID after provisioning.

Answer: D

NEW QUESTION 5
An engineer configures a Cisco Aironet 600 Series OfficeExtend AP for a user who works remotely. What is configured on the Cisco WLC to allow the user to print a printer on his home network?

• A. split tunneling
• B. SE-connect
• C. FlexConnect
• D. AP failover priority

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/support/docs/wireless/aironet-602-officeextend-access-point/117540-configure-splittunneloeap-00.html

NEW QUESTION 6
Refer to the exhibit. A network administrator deploys the DHCP profiler service in two ISE servers: 10.3.10.101 and 10.3.10.102. All BYOD devices connecting to WLAN on VLAN63 have been incorrectly profiled and are assigned as unknown profiled endpoints. Which action efficiently rectifies the issue according to Cisco recommendations?

• A. Nothing needed to be added on the Cisco WLC or VLAN interfac
• B. The ISE configuration must be fixed.
• C. Disable DHCP proxy on the Cisco WLC.
• D. Disable DHCP proxy on the Cisco WLC and run the ip helper-address command under the VLAN interface to point to DHCP and the two ISE servers.
• E. Keep DHCP proxy enabled on the Cisco WLC and define helper-address under the VLAN interface to point to the two ISE servers.

Answer: C

NEW QUESTION 7
A corporation has recently implemented a BYOD policy at their HQ. Which two risks should the security director be concerned about? (Choose two.)

• A. network analyzers
• B. malware
• C. lost and stolen devices
• D. keyloggers
• E. unauthorized users

Answer: BC

NEW QUESTION 8
An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?

• A. learn client IP address
• B. FlexConnect local authentication
• C. VLAN-based central switching
• D. central DHCP processing

Answer: C

NEW QUESTION 9
A user is trying to connect to a wireless network that is configured for WPA2-Enterprise security using a corporate laptop. The CA certificate for the authentication server has been installed on the Trusted Root Certification Authorities store on the laptop. The user has been prompted to enter the credentials multiple times, but the authentication has not succeeded. What is causing the issue?

• A. There is an IEEE invalid 802.1X authentication policy on the authentication server.
• B. The user Active Directory account is locked out after several failed attempts.
• C. There is an invalid 802.1X authentication policy on the authenticator.
• D. The laptop has not received a valid IP address from the wireless controller.

Answer: C

NEW QUESTION 10
On a branch office deployment, it has been noted that if the FlexConnect AP is in standalone mode and loses connection to the WLC, all clients are disconnected, and the SSID is no longer advertised. Considering that FlexConnect local switching is enabled, which setting is causing this behavior?

• A. ISE NAC is enabled
• B. 802.11r Fast Transition is enabled
• C. Client Exclusion is enabled
• D. FlexConnect Local Auth is disabled

Answer: D

NEW QUESTION 11
A customer is experiencing performance issues with its wireless network and asks a wireless engineer to provide information about all sources of interference and their impacts to the wireless network over the past few days. Where can the requested information be accessed?

• A. CleanAir reports on Cisco Prime Infrastructure
• B. Performance reports on Cisco Prime Infrastructure
• C. Interference Devices reports on Cisco Wireless LAN Controller
• D. Air Quality reports on Cisco Wireless LAN Controller

Answer: A

NEW QUESTION 12
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?

• A. SOAP/XML
• B. NMSP
• C. CAPWAP
• D. SNMP

Answer: A

NEW QUESTION 13
An engineer configured a Cisco AireOS controller with two TACACS+ servers. The engineer notices that when the primary TACACS+ server fails, the WLC starts using the secondary server as expected, but the WLC does not use the primary server again until the secondary server fails or the controller is rebooted. Which cause of this issue is true?

• A. Fallback is enabled
• B. Fallback is disabled
• C. DNS query is disabled
• D. DNS query is enabled

Answer: B

NEW QUESTION 14
For security purposes, an engineer enables CPU ACL and chooses an ACL on the Security > Access Control Lists > CPU Access Control Lists menu. Which kind of traffic does this change apply to, as soon as the change is made?

• A. wireless traffic only
• B. wired traffic only
• C. VPN traffic
• D. wireless and wired traffic

Answer: A

NEW QUESTION 15
During the EAP process and specifically related to the client authentication session, which encrypted key is sent from the RADIUS server to the access point?

• A. WPA key
• B. session key
• C. encryption key
• D. shared-secret key

Answer: B

NEW QUESTION 16
What is the default NMSP echo interval between Cisco MSE and a Wireless LAN Controller?

• A. 10 seconds
• B. 15 seconds
• C. 30 seconds
• D. 60 seconds

Answer: B

Explanation:
Reference: https://www.cisco.com/en/US/docs/wireless/mse/3350/6.0/CAS/configuration/guide/msecg_ch4_CAS.html

NEW QUESTION 17
Which two protocols are used to communicate between the Cisco MSE and the Cisco Prime Infrastructure network management software? (Choose two.)

• A. HTTPS
• B. Telnet
• C. SOAP
• D. SSH
• E. NMSP

Answer: AE

NEW QUESTION 18
Which AP model of the Cisco Aironet Active Sensor is used with Cisco DNA Center?

• A. 1800s
• B. 3600e
• C. 3800s
• D. 4800i

Answer: A

NEW QUESTION 19
Which devices can be tracked with the Cisco Context Aware Services?

• A. wired and wireless devices
• B. wireless devices
• C. wired devices
• D. Cisco certified wireless devices

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/support/docs/wireless/context-aware-software/110836-cas-faq.html

NEW QUESTION 20
An engineer is configuring multicast for wireless for an all-company video meeting on a network using EIGRP and BGP within a single domain from a single source. Which type of multicast routing should be implemented?

• A. Protocol Independent Multicast Dense Mode
• B. Source Specific Multicast
• C. Multicast Source Discovery Protocol
• D. Protocol Independent Multicast Sparse Mode

Answer: D

NEW QUESTION 21
An engineer must configure a Cisco WLC to support Cisco Aironet 600 Series OfficeExtend APs. Which two Layer 2 security options are supported in this environment? (Choose two.)

• A. Static WEP + 802.1X
• B. WPA+WPA2
• C. Static WEP
• D. CKIP
• E. 802.1X

Answer: BC

NEW QUESTION 22
Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

• A. RF Profile
• B. Flex Profile
• C. Policy Profile
• D. AP Join ProfileCorrect

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/flexconnect.html

NEW QUESTION 23
Where is Cisco Hyperlocation enabled on a Cisco Catalyst 9800 Series Wireless Controller web interface?

• A. Policy Profile
• B. AP Join Profile
• C. Flex Profile
• D. RF Profile

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/cisco-hyperlocation.html

NEW QUESTION 24
A wireless engineer needs to implement client tracking. Which method does the angle of arrival use to determine the location of a wireless device?

• A. received signal strength
• B. triangulation
• C. time distance of arrival
• D. angle of incidence

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/WiFiLBS-DG/wifich2.html

NEW QUESTION 25
An engineer is performing a Cisco Hyperlocation accuracy test and executes the cmxloc start command on Cisco CMX. Which two parameters are relevant? (Choose two.)

• A. X, Y real location
• B. client description
• C. AP name
• D. client MAC address
• E. WLC IP address

Answer: AD

NEW QUESTION 26
......