
we provide Accurate Cisco 300 070 ciptv1 real exam which are the best for clearing 300 070 ciptv1 test, and to get certified by Cisco Implementing Cisco IP Telephony & Video, Part 1 v1.0. The 300 070 ciptv1 Questions & Answers covers all the knowledge points of the real 300 070 ciptv1 pdf exam. Crack your Cisco 300 070 ciptv1 pdf Exam with latest dumps, guaranteed!
Q61. Which of the following simplifies and enhances conference resource management?
A. Cisco Telepresence Server
B. Cisco Telepresence MCU
C. Cisco Telepresence MSE 8000
D. Cisco IOS routers with packet voice/data module (PVDM)
E. Cisco Telepresence Conductor
Answer: C
Q62. The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series
servers, eachone capable of supporting 7500 devices. The design must meet these requirements:
-Be cost-effective
-Support up to 7500 phones
-Provide a minimal level of redundancy
A. Two Cisco Unified Communications Manager servers:
1 publisher and TFTP server combined.
1 primary subscriber.
B. Three Cisco Unified Communications Manager servers:
1 publisher and TFTP server combined.
1 primary subscriber.
1 backup subscriber.
C. Four Cisco Unified Communications Manager servers:
1 publisher.
1 TFTP server.
1 primary subscriber.
1 backup subscriber.
D. Five Cisco Unified Communications Manager servers:
1 publisher.
1 TFTP server.
1 primary subscriber.
2 backup subscribers.
Answer: B
Q63. A customer recently installed a Cisco TelePresence MCU 5320. The customer wants a
virtual meetingroom that restricts participants from communicating before the customer joins the call.
Which featurein the MCU enables this functionality?
A. Floor and chair control.
B. Numeric ID.
C. PIN codes.
D. Owner.
Answer: A
Explanation: Reference:
http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/mcu/admin_guide/cis co_telepresence_mcu_5300_series_administration_guide_4-3_2-17.pdf
Q64. Which three CLI commands allow you to verify the correct VoIP dial-peer matching? (Choose three.)
A. debug ccsip messages
B. debug voip ccapi inout
C. debug dialpeer match
D. debug voip dialpeer inout
E. show dialplan number
Answer: B,D,E
Q65. Refer to the exhibit.
A Network Administrator needs to create a SIP route pattern to communicate with Monterrey's Gateway.
The Administrator does not understand why this is not working properly. Which two statementsexplain the issue and resolve the problem?(Choose two.)
A. The issue is caused by a failure of communication between the Monterrey's Gateway and CUCM.
B. The Administrator should type the reload command into Monterrey's Gateway.
C. The issue is caused by incorrect protocol integration between Monterrey's Gateway and CUCM.
D. The Administrator needs to set up a SIP trunk between Monterrey's Gateway and CUCM.
Answer: C,D
Q66. On what equipment do you configure Layer 2 to Layer 3 QoS mapping?
A. switch
B. router
C. firewall
D. Cisco Unified Communications Manager
E. bridge
Answer: B
Q67. By default, what value is voice traffic marked as on a Cisco Catalyst Switch?
A. DSCP EF value 46, Cos 5.
B. DSCP EF value 46, Cos 7.
C. DSCP CAS6 value 21, Cos 3.
D. DSCP AF21, Cos 5.
Answer: A
Q68. Which three of these are characteristics of a Cisco Unified Communications Manager software- basedMedia Termination Point? (Choose three.)
A. The codec and packetization of both call legs must be identical.
B. This Media Termination Point type does not require any DSP resources on the Cisco router.
C. DSP resources are required.
D. It can provide G.711 mu-law to G.711 a-law conversion and vice versa.
E. It can provide packetization conversion for a given codec (for example, if one call leg is using a 20-mssampe size, but the other call legis using a 30-ms sample size).
F. This Media Termination Point type is typically used for RSVP agent configurations or Cisco Unified borderelementmedia flow-through configuration.
Answer: B,D,E
Q69. Which discard digits instruction removes all digits prior to the North American Numbering Plan portion of the route pattern?
A. PreDot
B. PreAt
C. Pre
D. PreNANP
Answer: B
Q70. Which DSCP classification is defined in RFC 2474?
A. DSCP CS3.
B. DSCP 0.
C. DSCP AF11.
D. DSCP CS6.
E. DSCP EF.
F. DSCP CS2.
G. DSCP CS1.
H. DSCP AF21.
Answer: A
Explanation: Reference:
Page 24
CIPTV110SG_Vol2